Nissan Micra 2002 - 2010 - The most common problems and breakdowns
What are the most common Nissan Micra failures and how to fix them?
Nissan Micra - ALL MODELS
Issue - The rear fog light illuminates continuously.
Cause - Software error in multifunction control module.
Repair - Test and, if necessary, replace electronic and mechanical components. If no error is found, install a new multifunction control module.
Nissan Micra - ALL MODELS S ABS-OM
Issue - Control the ABS light is on.
Cause - Damaged rear wheel speed encoder.
Repair - Install a new rear wheel speed encoder.
Nissan Micra - MODELS WITH CR / VQ ENGINE CODES, 04/2006
Issue - Engine failure indicator illuminates, engine shut off and low traction.
Cause - Occasional loss of crankshaft position encoder signal.
Repair - Check and clean flywheel, replace crankshaft position transducer (CKP).
Nissan Micra - ALL MODELS, FROM VIN SJNEBAK12U1048427
Issue - It is not possible to lock / unlock the vehicle using the keyless entry system.
Cause - Invalid keyless entry control module.
Repair - Remove fuse F17 from the fuse box / relay board. Wait 5 minutes before inserting Fuse F17. If the keyless entry system is working properly, replace the keyless entry control module.
Nissan Micra - ALL MODELS WITH GASOLINE ENGINES, FROM 05/2003
Issue - Engine trimming and shutdown.
Cause - Poor ECM ground connection.
Repair - Check the engine computer mass (ECM) as necessary.
Nissan Micra - ALL MODELS WITH ENGINE CODE CR, FROM 05/2006
Issue - Coolant leakage from thermostat housing.
Cause - Defective thermostat housing seal.
Repair - Install a modified thermostat housing seal.
Micra - ALL MODELS WITH ENGINE CODES CR10DE8CR12DE / CR14DE
Issue - Engine failure indicator illuminates.
Cause - Stretched and worn timing chain.
Repair - Replace timing chain. Check that the pulleys and timing chain tensioner are worn and replace as necessary.
Micra - DIESELS 1.5 DCi
Issue - It is not possible to start after replacing the timing belt. Valve phase adjustment incorrect after timing belt replacement.
Cause - Invalid valve phase due to camshaft pulley error.
Repair - Remove the camshaft pulley, check for damage and replace if necessary.
Micra - ALL MODELS, VIN SJN *** K12U1047087 / SJN *** K12U2141308
Issue - Loose steering wheel.
Cause - Improper steering wheel bolt version.
Repair - Install the modified safety bolt. Tighten the locking screw to 29-39 Nm.
Source: autoportal.hr
Recommendation of similar texts:
Hi there, I am Mladen and I am an auto enthusiast. I started this blog years ago to help like minded people share information about latest cars, car servicing ideas, used car info, exotic cars, and auto technology. You will find helpful articles and videos on a wide variety of cars - Audi, Mercedes, Toyota, Porsche, Volvo, BMW and much more. Ping us if you have anything cool to share on latest cars or on how to make older cars more efficient, or just want to say hi!
The reverse light does not work. Bulb and fuse correct