Nissan Micra 2002 - 2010 - The most common problems and breakdowns

Nissan Micra - ALL MODELS
Issue - The rear fog light illuminates continuously.
Cause - Software error in multifunction control module.
Repair - Test and, if necessary, replace electronic and mechanical components. If no error is found, install a new multifunction control module.

Nissan Micra - ALL MODELS S ABS-OM
Issue - Control the ABS light is on.
Cause - Damaged rear wheel speed encoder.
Repair - Install a new rear wheel speed encoder.

Nissan Micra - MODELS WITH CR / VQ ENGINE CODES, 04/2006
Issue - Engine failure indicator illuminates, engine shut off and low traction.
Cause - Occasional loss of crankshaft position encoder signal.
Repair - Check and clean flywheel, replace crankshaft position transducer (CKP).

Nissan Micra - ALL MODELS, FROM VIN SJNEBAK12U1048427
Issue - It is not possible to lock / unlock the vehicle using the keyless entry system.
Cause - Invalid keyless entry control module.
Repair - Remove fuse F17 from the fuse box / relay board. Wait 5 minutes before inserting Fuse F17. If the keyless entry system is working properly, replace the keyless entry control module.

Nissan Micra - ALL MODELS WITH GASOLINE ENGINES, FROM 05/2003
Issue - Engine trimming and shutdown.
Cause - Poor ECM ground connection.
Repair - Check the engine computer mass (ECM) as necessary.

Nissan Micra - ALL MODELS WITH ENGINE CODE CR, FROM 05/2006
Issue - Coolant leakage from thermostat housing.
Cause - Defective thermostat housing seal.
Repair - Install a modified thermostat housing seal.

Micra - ALL MODELS WITH ENGINE CODES CR10DE8CR12DE / CR14DE
Issue - Engine failure indicator illuminates.
Cause - Stretched and worn timing chain.
Repair - Replace timing chain. Check that the pulleys and timing chain tensioner are worn and replace as necessary.

Micra - DIESELS 1.5 DCi
Issue - It is not possible to start after replacing the timing belt. Valve phase adjustment incorrect after timing belt replacement.
Cause - Invalid valve phase due to camshaft pulley error.
Repair - Remove the camshaft pulley, check for damage and replace if necessary.

Micra - ALL MODELS, VIN SJN *** K12U1047087 / SJN *** K12U2141308
Issue - Loose steering wheel.
Cause - Improper steering wheel bolt version.
Repair - Install the modified safety bolt. Tighten the locking screw to 29-39 Nm.

Source: autoportal.hr