How to replace the battery properly

BATTERY

Battery

A battery is a gadget used in cars that serves as an energy storage. In it, electricity is converted to chemical energy, called battery charging, and can then be re-converted to electrical energy as needed, which is called discharging. They are used to start internal combustion engines although they have relatively low capacity. However, despite this drawback, they are much used as they are the only known and easily portable power tanks for now.

Today, batteries at different prices are available at every auto parts store. Usually the more expensive it is, the higher the quality, though it may not be the rule. Also, since it is an easily accessible and easily accessible part of the vehicle, any driver with or without skillful hands can change it alone, in their garage or yard.

Before replacing, you should know that there are dangerous liquids in every battery, so you need to protect yourself. It is best to take protective gloves and goggles to protect yourself. Also, before changing, you need to turn off the vehicle and remove the key from the ignition. In addition, you need to equip yourself with the necessary tools.

Here's how to change your battery in five steps:

Step 1 - first unscrew the battery holder, then use a wrench to release the battery negative terminal and then disconnect the terminal. When you have done this for the negative sex, everything should be repeated for the positive. It is important that you do not touch the key with both sexes at the same time.

Step 2 - then raise the battery. Gently lift and lift it out of the housing in which it stands and store it in a safe place. It is good to mix half a liter of water and one teaspoon of soda and put a toothbrush in that mixture and use it to clean any places where corrosion has occurred. After you have done that, you need to dry all parts of the stand with a dry cloth.

Step 3 - Put the new battery pack in the case before you prepare it. Make sure that the poles are turned correctly, that the negative and positive are facing in the right direction, and then secure the brackets.

Step 4 - It is good to coat the poles of the battery with Vaseline in order to slow down and prevent the effect of corrosion. Once you have done that, put the negative terminal on the negative pole and the positive on the positive.

Step 5 - Close the hood. Start the engine and make sure that the engine is running properly or that the engine is running smoothly. And that is that! If it works without a problem means you did a great job and we congratulate you!

In addition, you should know that the battery must never run out of electrolytes because it simply cannot work without them. For that reason, it is necessary to check their level from time to time. Namely, with normal operation, the battery loses them. When checking them, the liquid in the battery must cover its plates by approximately 10 millimeters. If we notice that there is less of it, distilled water should be added. The acid should not be added because it concentrates by evaporation and does not lose it. There are batteries that are declared not to need to be checked, however it is good to check them from time to time, just in case.

Often, instead of buying a new one, the old battery is removed and charged. We need an adapter for this. Charging should not exceed 1/10 of the capacity in Ah because if it is higher, the full capacity of the battery will not be obtained. Charging is done through the rectifier and its voltage should be regulated during charging.

Battery life depends on maintenance, but also on how it is. For lead, the shelf life is limited to three to four years, and for rechargeable batteries and less, up to two years. If they are not intended for charging, they should not be forced to do so as they may explode when charging.

Source: www.silux.hr

Leave a reply