Little tips on repairing the central lock

In the newer generation of cars, it is an integral part of the equipment, but the central lock can also be retrofitted to the car. It is necessary to procure the necessary real, electric motors, a few more parts and it can be installed in any vehicle.

There is a possibility of mounting the mechanism on the trunk of the vehicle. Installing this device gives you the ability to open the trunk via the remote control.

Like any other device, the central lock is subject to failures. The most common failures are electric motor failure and lock failure.

1. An electric motor malfunction may be the following: the engine may lose power or become weak, if such a malfunction occurs, you need to have the motor inspected by an electrician, or buy a new motor and replace it.

2. The lock failure may be as follows. one of the very common reasons that the lock does not work is to collect the dust in the mechanism itself, so the accumulated dust starts to interfere with time, makes it difficult to lock the mechanism, and then the electric motor does not have enough power to pull the cable and unlock the door.

If the lock breaks, and you want to fix the fault yourself, do the following: take a screwdriver and remove the lock, the removal procedure is different from vehicle to vehicle, but in principle it is not difficult, it is usually necessary to remove the inner side of the door. handrails, window handles and everything else on the door, then the whole page, and then you get access to the locks. When disassembling the lock as well as the engine, disassemble it and try to clean it as much as you can, to remove dust from it to facilitate the operation of the mechanism.

It is recommended to check the operation of the engine, if you do not know how to do it yourself, take it to your car electrician for testing. If everything is OK with the engine, then start cleaning the lock and try if it works. Cleaning alone will usually solve the problem. If you have cleaned the lock and checked the operation of the engine and the system still does not work, contact your car electrician.

Frozen central lock

Winter days are approaching and icy locks are a common problem. The central lock as well as all other locks can be frozen. There are various ways to defrost locks.

1. Put glycerin on the key and turn the key carefully.

2. Spray WD40 in the lock and leave a minute to act then try to unlock the lock

3. Pour a little alcohol or spirits into the lock after 5 minutes to try to unlock the lock

4. Trying to open the lock with the remote control sometimes wants to unlock the lock from the third attempt until the key can be opened

5. Spray a special spray for defrosting the locks that you can get at each gas station. In addition, it is important to coat the cedar as there is a possibility of water entering between the cedar and the metal part. You can solve this problem by purchasing a special cedar stick or simply coat them with glycerin.

Source: www.autostart.co.rs