Categories: FordUsed cars

Ford Kuga 2008 - 2012 - The most common problems and breakdowns

Ford Kuga

What are the most common problems and failures of the Ford Kuga and how to solve them?

Ford Plague - ALL MODELS 
PROBLEM - The engine does not start. Fault in one or more electrical systems.
CAUSE - Moisture in the fuse box / relay board connections due to condensation from the evaporator tube of the air conditioner.
REPAIR - Check components, electronics and mechanics to eliminate other possible causes. If no error is found: reprogram the control module with the upgraded software. Check for water damage at the fuse box / relay board connector and repair / replace as needed. Install the sponge on the air conditioning evaporator tube above the fuse box / relay board.

Ford Kuga - ALL MODELS 
PROBLEM - Frequent headlight bulbs burn out.
CAUSE - Headlight bulb supply voltage too high.
REPAIR - Install the resistor set between the bulbs and the headlamp wiring harness connector.

Ford Kuga - MODELS WITH 5TH GEAR 
PROBLEM - Leakage of oil from the power transmission mechanism to the wheels.
CAUSE - Improperly installed right drive shaft damages the seal.
REPAIR - Install a new drive shaft seal. The drive shaft should be pushed as far into the transmission as possible. Replace the middle drive shaft bearing nuts and bracket.

Ford Kuga - DIESEL MODELS 2.0 
PROBLEM - Engine Malfunction Indicator Lamp (MIL) illuminates. The engine leaks fuel and loses power.
CAUSE - Damaged or incorrectly installed O-rings on the fuel injector return pipe connector.
REPAIR - Inspect for leaks or damage to the fuel injector return pipe connector. If necessary, replace the fuel injector return pipes. Lubricate the O-rings. Install new fuel injector return hooks.

Ford Plague - DIESEL MODELS 2.2 AND PETROL 2.5 WITH MANUAL GEARBOX 
PROBLEM - Unable to change gears.
CAUSE - Transmission lever ball joint dislocated from the selector lever.
REPAIR - Apply Loctite to the gear lever ball screw. Install the selector lever ball joint to the selector lever. Tightening torque: 20 ± 3 Nm. Install the shift selector cable to the selector lever ball joint.

Retrieved from: autoportal.hr


View Comments

  • I have a problem with the Ford Plague 2.0
    When I squeeze the gas he throws smoke as soon as possible?
    What can it be

Recent Posts

Used B5 Passat 1.9 TDI versus Used Audi A3 1.9 TDI: Comparing the TDI Experience

The Volkswagen I9 1.9L turbocharged direct injection (TDI) diesel engine powers two favorites among European…

7 months ago

Car Maintenance Tips for Older Cars

Automobile / Car Brands on Older Cars The automobile business has changed the manner in…

12 months ago

The problems and malfunctions faced using the Honda Accord and how to fix them

The Honda Accord is a line of automobiles produced by Honda since 1976. Its four-door…

1 godina ago

How to maintain older German cars like BMW economically for cars with over 100000 miles

Maintaining an older German car like a BMW can be challenging, especially once it reaches…

1 godina ago

Classic Car Maintenance: Fluids

To begin, let's look at petrol and diesel. Aside from making sure you have enough…

2 years ago

Bentley Continental GT 2010-2018 Used, Experiences and Common Issues Found

Bentley motors, a name delivering quality and astounding SUVs, unleashed Bentley Continental GT from 2003…

2 years ago