Opel Insignia
Opel Insignia
Opel Insignia - ALL MODELS
PROBLEM - Engine Malfunction Indicator Lamp (MIL) illuminates.
CAUSE - Excessive operation of ABS / TCS in difficult weather conditions (snow / ice).
REPAIR - Test electronics and mechanics components to eliminate other possible causes. If no error is found: Access the ECM error memory and clear the error codes.
Opel Insignia - ALL MODELS
PROBLEM - Clicking from the front wheel at startup.
CAUSE - Clearance between front hub and drive shaft.
REPAIR - Lubricate the drive shaft and front hub contact surfaces.
Opel Insignia - ALL MODELS
PROBLEM - Steering wheel vibration at 110 - 145 km / h.
CAUSE - Worn rear front lower arm bracket.
REPAIR - Replace the lower suspension rear bearing on both sides. Check tire condition, tire pressure, wheel balance and wheel geometry.
Opel Insignia - ALL MODELS
PROBLEM - The tailgate / tailgate will not open when the release switch is pressed.
CAUSE - Faulty tailgate / rear door switch.
REPAIR - Install a new tailgate / rear door switch.
Opel Insignia A16XER / A18XER
PROBLEM - Knocking from the engine when starting, after a long engine stop.
CAUSE - Premature operation of the camshaft position (CMP) actuator due to a fault in the engine computer software (ECM).
REPAIR - Test components, electronics and mechanics to eliminate other possible causes. If no error is found: Reprogram the engine computer (ECM) with upgraded software.
Opel Insignia - MODELS WITH MANUAL GEARBOX
PROBLEM - It is difficult to activate gears.
CAUSE - Central clutch plate blocked on transmission input shaft.
REPAIR - Remove the transmission. Clean and lubricate the transmission input shaft grooves. Refit the transmission.
Opel Insignia - ALL MODELS WITH CODE LLU / A16LET
PROBLEM - The engine vibrates at low acceleration.
CAUSE - Engine computer software (ECM) error.
REPAIR - Test electronics and mechanics components (as needed) to eliminate other possible causes. If no error is found: Program again engine computer (ECM) with upgraded software.
Opel Insignia - ALL MODELS WITH CODE LLU / A16LET
PROBLEM - Hesitation when accelerating under light load.
CAUSE - Engine Computer (ECM) - Software folder error.
REPAIR - Test electronics and mechanics components (as needed) to eliminate other possible causes. If no error is found: Reprogram the engine computer (ECM) with the upgraded software.
Opel Insignia - ALL MODELS WITH LDK / A20NHT CODE
PROBLEM - Engine Malfunction Indicator Lamp (MIL) illuminates. Occasional loss of power during acceleration.
CAUSE - Engine computer software (ECM) error. Turbocharger Charging Pressure (TC) Control System Fault.
REPAIR - Inspect the turbine charge pressure control system (TC). Replace / repair components as needed. Reprogram the engine computer (ECM) with the updated software.
Opel Insignia CDTI 2.0
PROBLEM - Loss of engine power. Unusual noise from the engine.
CAUSE - Uncontrolled operation of the air flow control valve on the intake manifold.
REPAIR - Remove the intake manifold. Inspect the intake manifold air control system. Replace / repair components as needed. Check for engine damage. Replace / repair components as needed.
Opel Insignia CDTI 2.0
PROBLEM - The engine failure (MIL) light is on. Loss of engine power. Engine downtime.
CAUSE - The fuel injector electrical wiring assembly rubs against the duct causing a short circuit.
REPAIR - Install a new fuel injector electrical assembly. Access the ECM error memory and clear the error codes.
Opel Insignia CDTI 2.0
PROBLEM - Improper operation and variation of idle speed.
CAUSE - Engine computer software error (ECM).
REPAIR - Test electronics and mechanics components (as needed) to eliminate other possible causes. If no error is found: Reprogram the ECM with the modified software. Program the injector calibration code in the engine computer (ECM).
Opel Insignia CDTI 2.0
PROBLEM - The engine failure (MIL) light is on. The engine loses power.
CAUSE - Loose, damaged, or missing the EGR radiator vacuum connector plug.
REPAIR - Check the condition and condition of the EGR radiator vacuum plug. Replace if necessary.
Opel Insignia CDTI 2.0
PROBLEM - The engine oil level indicator light illuminates after a cold start, even though the level is correct.
CAUSE - Engine computer software (ECM) error.
REPAIR - Test components, electronics and mechanics (as needed) to eliminate other possible causes. If no error is found: program the engine computer (ECM) with upgraded software.
Opel Insignia CDTI 2.0
PROBLEM - Noise and vibration under the vehicle at approximately 1500 - 2000 rpm, at low speed.
CAUSE - Faulty turbocharger control (TC) solenoid valve.
REPAIR - Install the modified turbocharger control (TC) solenoid valve.
Opel Insignia 2.0 CDTI SA SOIL FILTER (DPF)
PROBLEM - A warning code 'Code 55' or 'check DPF' appears on the multifunction display.
CAUSE - Interrupted the regeneration process due to an error in the parameter map in the engine computer (ECM).
REPAIR - Initiate forced regeneration Particulate Filter (DPF), using manufacturer's diagnostic equipment or the like.
Opel Insignia A20DTH
PROBLEM - The engine failure (MIL) light is on. The engine loses power.
CAUSE - Engine computer software (ECM) error.
REPAIR - Test electronics and mechanics components (as needed) to eliminate other possible causes. If no error is found: reprogram the ECM with the modified software.
Opel Insignia - MODELS WITH LBW / A28NET CODE
PROBLEM - A 'low refrigerant' warning message is displayed, although the level is correct.
CAUSE - Improper version of the refrigerant expansion vessel.
REPAIR - Install the modified engine coolant expansion tank.
Opel Insignia - PETROL MODELS 2.8 2008-09.
PROBLEM - The engine failure (MIL) light is on.
CAUSE - Excessive wear on the timing chains causes incorrect signals from the camshaft position (CMP) sensor. A software upgrade is required for effective repair - contact the manufacturer.
REPAIR - Replace timing chains and spanners and, if necessary, sprockets. Check that the engine computer (ECM) is programmed at service intervals of 15.000 km and program if necessary.
Opel Insignia - PETROL MODELS 2.8 WITH AUTOMATIC TRANSMISSION
PROBLEM - Deteriorated engine performance at high speeds. The car does not reach the declared top speed.
CAUSE - Software incompatibility between engine computer (ECM) and transmission control module (TCM).
REPAIR - Test electronics and mechanics components (as needed) to eliminate other possible causes. If no error is found: Reprogram the ECM with the modified software.
Retrieved from: autoportal.hr
Hi there, I am Mladen and I am an auto enthusiast. I started this blog years ago to help like minded people share information about latest cars, car servicing ideas, used car info, exotic cars, and auto technology. You will find helpful articles and videos on a wide variety of cars - Audi, Mercedes, Toyota, Porsche, Volvo, BMW and much more. Ping us if you have anything cool to share on latest cars or on how to make older cars more efficient, or just want to say hi!
The Volkswagen I9 1.9L turbocharged direct injection (TDI) diesel engine powers two favorites among European…
Automobile / Car Brands on Older Cars The automobile business has changed the manner in…
The Honda Accord is a line of automobiles produced by Honda since 1976. Its four-door…
Maintaining an older German car like a BMW can be challenging, especially once it reaches…
To begin, let's look at petrol and diesel. Aside from making sure you have enough…
Bentley motors, a name delivering quality and astounding SUVs, unleashed Bentley Continental GT from 2003…
View Comments
I have a problem with the opel insignia, I stopped at the gas station to refuel and suddenly the car started on more. It doesn't even light up all the possible lights is a 2014 model 2.0 cdti